HUG Hydronics
Combi Boiler Fitting Kit (With Fittings)
Couldn't load pickup availability
This kit requires you buy a Combi boiler from us to receive the fittings.
COMBI Boiler's needs an adapter to work the HUG Hydronics In-Floor Heating System. This is that adapter. Now, with one huge COMBI Boiler, you can heat your house and your hot water with the same boiler. A good match for this adapter is the NKC199N natural gas combi boiler.
* Installs with 1 tool, about 5 minutes of work.
How does it work?
Combis have a pressure sensor which our adapter replaces with a low water level sensor and air remover. The probe senses if the water is low. If it is it sends a signal to the purge pins to run the pump 3 seconds, raising the water level enough to purge any air.
The water sensing probe gets stuck down a tube on the top, and the power cord goes down a hole and plugs into the circuit board of the COMBI Boiler. On the HUG Hydronics Tanks the black box slips in next to the thumb screws on the back. A hose goes into the tank and a connecting cord feed to the control board and plugs into the purge pins of the heater pump (usually pump #10).
This includes:
(2) 1" PEX to 1" FIP fittings
(3) Wall clamps to mount the cable from the adapter
(1) Lochinvar bypass jumper cable
(1) Combi Adapter
Key Features
-
Use our Wizard to personalize your System:
or Ask for a QuoteIt will help you choose your heat sources, loops, and accessories for a complete 1 stop shopping experience.
-
Supports 4 Thermostat Zones with Priority Zone Settings
What's a "Low Priority" zone?Now up to 8 heating zones!
Any heating loop can be assigned to any thermostats by simply moving a jumper.
-
Easily works with up to 3 heat sources
Such as electric, gas, solar, heat pumps,or wood. Great for off-peak electric and dual fuel applications.
-
Simple & Understandable
Easy installation and maintenance. Installs with basic tools. Replace any part with basic or no tools. and it's easy to add water for start-up.
